mancSLO 1 945 Napisano October 4, 2014 Share Napisano October 4, 2014 Z Innbox V50U Home Gateway od Siola nikakor ne morem postaviti serverja. Na server listi svoj server vidim, ping pa je n/a in avtov tudi ni v okencu za izbiro. Ali lahko pomagate? Citiraj Link to post
B_U_R_I 3 290 Napisano October 5, 2014 Share Napisano October 5, 2014 Marjan, si delal po tem Dej nared en printscreen od nastavitev ... Citiraj Link to post
mancSLO 1 945 Napisano October 5, 2014 Avtor Share Napisano October 5, 2014 Slike sem ti poslal na ZS. Ker pa sem ugotovil, da imam na ETH 1 izhodu polovično hitrost proti ETH2 na modemu, je verjetno kaj v okvari? Citiraj Link to post
AliBuggy 1 008 Napisano October 20, 2014 Share Napisano October 20, 2014 Hmm...jaz imam z zadnjo verzijo tudi tezave na istem modemu. Je kaksen hakeljc pri vsem tem ali jaz kaj posebej narobe delam? Naredil po navodilih kot so opisana odprt TCP/UDP za vse tri porte...dodal se v Port triggering...nic.CMD output javi lepo staus OK, vendar se ne morem povezati na svoj server...isti simptomi kot pri OP DynamicTrack: first session, resetting grip SENDING session name : Qualify SENDING session index : 0 SENDING session type : 2 SENDING session time : 5 SENDING session laps : 0 SENDING http://93.57.10.21/lobby.ashx/ping?sess... nts=0&track=imola&pickup=1 OK Je komu uspelo narediti pravi port FWD na tem SIOL modemu in kako? V cem je tezava? Citiraj Link to post
B_U_R_I 3 290 Napisano October 20, 2014 Share Napisano October 20, 2014 Težava je v tem, da ta modem nima možnosto NAT Loopbacka. To pomeni, da znotraj svoje mreže ne moreš vzpostaviti povezave, k igre ven iz lokalnega omrežja (v internet, do KUNOS strežnikov) in potem zopet od zunaj nazaj notri. Ena rešitev je ta, da ročno vzpostaviš PPPoE povezavo z računalnika, na katerem teče AC server. Drugih zaenkrat še nisem našel (poleg seveda očitnega - nabava lastnega routerja) Po drugi strani je malce zmeden način prijave tudi s strani Assetto Corsa, da se moraš na lastni strežnik povezovat od zunaj. Citiraj Link to post
AliBuggy 1 008 Napisano October 21, 2014 Share Napisano October 21, 2014 Matjaž, Hvala za info. Sem se ze prekleto nasekiral kaj delam narobe. Potemtakem drugi moj server naceloma vidijo (nisem probaval) jaz pa bi se pa potem teoreticno lahko povezal preko LAN opcije v AC. Bom preizkusil se to. Hvala se enkrat. Lp, Ales Citiraj Link to post
mancSLO 1 945 Napisano October 21, 2014 Avtor Share Napisano October 21, 2014 Takole narediš povezavo: http://www.telekom.si/pomoc-in-podpora/teme-pomoci/internet/internet-siol/nastavitev/vzpostavitev-pppoe-povezave-windows-8 Citiraj Link to post
AliBuggy 1 008 Napisano October 21, 2014 Share Napisano October 21, 2014 Takole narediš povezavo: http://www.telekom.si/pomoc-in-podpora/teme-pomoci/internet/internet-siol/nastavitev/vzpostavitev-pppoe-povezave-windows-8 to vem da lahko postavim SIOL modem v fukcijo zgolj modema (ne routerja), vendar ne bom zaradi AC serverja potem delal klicne povezave na 4ih racunalnikih, ki so se v hisi Citiraj Link to post
AliBuggy 1 008 Napisano October 21, 2014 Share Napisano October 21, 2014 Takole stestirano in povezava preko LAN session na lastni server deluje, pod pogojem da v konfiguraciji serverja (server_cfg.ini) ali preko server launcherja settiras UDP in TCP port na isto vrednost (v mojem primeru 9456) in na modemu tudi ustrezno nastavis TCP/UDP protokol za ta port na port FWDju. TRACK=imola SUN_ANGLE=72 MAX_CLIENTS=6 RACE_OVER_TIME=20 UDP_PORT=9456 TCP_PORT=9456 HTTP_PORT=8098 REGISTER_TO_LOBBY=1 PICKUP_MODE_ENABLED=1 SLEEP_TIME=1 VOTING_QUORUM=75 Tako da se je kolega od zunaj normalno prijavil na server preko internet searcha, jaz grem notri pa preko LAN session in normalno deluje stvar 2 Citiraj Link to post
B_U_R_I 3 290 Napisano October 22, 2014 Share Napisano October 22, 2014 Super. Preko javnega searcha verjetno še vedno ne moreš gor s tvoje mašine, ne? Citiraj Link to post
AliBuggy 1 008 Napisano October 22, 2014 Share Napisano October 22, 2014 Ne, zaradi limitacij SIOL modema v router nacinu, kot je bilo zgoraj ugotovljeno. Je pa kar se mene in ostalih tice vse popolnoma isto, le da grem v igro preko LAN session-a. V novem popravku 1.05 naj bi popravili tudi to da nerabis imeti obeh portov istih za uspesno povezavo preko LAN-a, nisem pa se probal. 1 Citiraj Link to post
silicijeva dolina 1 254 Napisano October 29, 2014 Share Napisano October 29, 2014 Obrazložitev nastavitev za AC server: [sERVER] NAME=AC #001 Abarth Festival ;name of the server CARS=abarth500_s1;ferrari_458 ;; models of the cars allowed in the server - always use lower case characters TRACK=magione;vallelunga;vallelunga-club;silverstone-international;nurburgring;imola ; tracks allowed on the server - always use lower case characters SUN_ANGLE=-8 ; angle of the position of the sun MAX_CLIENTS=15 ;; max number of clients (must be <= number of pits) RACE_OVER_TIME=20 ;; time remaining in seconds to finish the race from the moment the first one passes on the finish line ALLOWED_TYRES_OUT=-1 ;; penalty (-1 disabled) UDP_PORT=9600 ;; UDP port number TCP_PORT=9600 ;; TCP port number HTTP_PORT=8081 ;; Lobby port number PASSWORD=asdasd ;; server password LOOP_MODE=1 ;; the server restarts from the first track,, to disable this set it to 0 REGISTER_TO_LOBBY=1 ;; this must not be touched PICKUP_MODE_ENABLED=1 ;; if 0 the server start in booking mode. Warning: in pickup mode you have to list only a circuit under TRACK and you need to list a least one car in the entry_list SLEEP_TIME=1 ;; this must not be touched VOTING_QUORUM=75 ;; percentage of vote that is required for the vote to pass VOTE_DURATION=20 ;; time in seconds players must respond to voting BLACKLIST_MODE=0 ;; ban player -> 0 = for session duration, 1 = until server restart, 2 = for ever TC_ALLOWED=1 ;; 0 -> forced off, 1 -> factory; 2-> forced on ABS_ALLOWED=1 ;; 0 -> forced off, 1 -> factory; 2-> forced on STABILITY_ALLOWED=0 ;; Stability assist 0 -> OFF; 1 -> ON AUTOCLUTCH_ALLOWED=1 ;; Autoclutch assist 0 -> OFF; 1 -> ON DAMAGE_MULTIPLIER=0 ;; Damage from 0 (no damage) to 100 (full damage) FUEL_RATE=100 ;; Fuel usage from 0 (endless) to XXX (where 100 is the realistic one) TYRE_WEAR_RATE=100 ;; Tyre wear from 0 (endless) to XXX (where 100 is the realistic one) CLIENT_SEND_INTERVAL_HZ=15 ;; refresh rate of packet sending by the server. 10Hz = ~100ms. Higher number = higher MP quality = higher bandwidth resources needed. USE_FLOW_CONTROL=0 ;; Now this is unnecessary[DYNAMIC_TRACK] SESSION_START=90 ; % level of grip at session start RANDOMNESS=1 ; level of randomness added to the start grip LAP_GAIN=1 ; how many laps are needed to add 1% grip SESSION_TRANSFER=90 ; how much of the gained grip is to be added to the next session 100 -> all the gained grip. Example: difference between starting (90) and ending (96) grip in the session = 6%, with session_transfer = 50 then the next session is going to start with 93. [bOOK] ;; booking session - add this section only if your server is in booking mode NAME=Booking TIME=5 ;; in minutes[PRACTICE] NAME=Free Practice TIME=0 ;; in minutes WAIT_TIME=30 ;; in seconds[QUALIFY] NAME=Qualify TIME=15 ;; in minutes WAIT_TIME=30 ;; in seconds[RACE] NAME=Race LAPS=5 WAIT_TIME=60 ;; in seconds, this is the time of the start countdown 1 Citiraj Link to post
mancSLO 1 945 Napisano October 29, 2014 Avtor Share Napisano October 29, 2014 Innbox V50 imam nastavljen kot ruter in sicer deluje v redu (razen zgoraj omenjenih težav z NAT Loopbackom). Ali menite, da so ruterji v rangu 30 do 40€ močnejši kar se tiče jakosti WiFi signala? Citiraj Link to post
sennas 1 040 Napisano October 29, 2014 Share Napisano October 29, 2014 Ne, je prepoceni......router mora bit 100 če hočeš da je kaj od naprave..... Citiraj Link to post
skopusnik 1 374 Napisano October 29, 2014 Share Napisano October 29, 2014 Močnejši je sigurno kot tisti Siolov. Citiraj Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.